Oricom Secure 300 Instrukcja Użytkownika

Baby MonitorSecure 300User Guide

8 YOUR BABY MONITORParent unitFrom the Parent unit you can listen to your baby and operate the Baby unit by remote control.Talk (on side of unit)Press

9YOUR BABY MONITORParent unit chargerCharging lightIndicates Parent unit is charging.Power socketFor connection to mains power.Front Back

10 BASIC OPERATIONOnce you have set up your Baby Monitor, you will be able to hear the sounds in your baby’s room through the Parent Unit. And also se

11BASIC OPERATION• If the volume of the Parent Unit is turned off, an alert will sound when the audio picked up reaches the second red led.Note:Do no

12 BASIC OPERATIONTalk BackYou can use the talk back feature to talk to your baby.• Press and hold [Talk] key on the Parent unit to speak to baby. The

13BASIC OPERATIONLullabyThe Baby unit plays lullabies to gently soothe your baby back to sleep. Each lullaby is played repeatedly for 15 minutes. Sele

14 BASIC OPERATIONNote:Low battery alert can be suppresed by pressing any button.Charging the BatteryPlace the parent unit on its charger pod to charg

15TROUBLESHOOTINGProblem Possible cause(s)The red power lights do not turn on when you plug in the power.1. Check if the units are properly connected

16 PRODUCT SPECIFICATIONSFeature Specifi cationsOperating Frequency 1.8 GHzRangeUp to 300 m under optimum conditions. The range is reduced in buildings

17GUARANTEEWarranty (Australia)(a) Warranty Oricom International Pty Ltd (Oricom) warrants that the product is free from defects in materials and wor

TABLE OF CONTENTSWARNINGS AND SAFETY INFORMATION 1GETTING STARTED 3YOUR BABY MONITOR 6BASIC OPERATION 10TROUBLESHOOTING 15PRODUCT SPECIFICATIONS

AustraliaOricom International Pty LtdLocked Bag 658South Windsor, NSW 2756Customer SupportEmail: [email protected]: www.oricom.com.auPhone: 130

1Do not place the cord in a high "wear and tear" location. Never use a frayed or compromised cord.Never use or place your Parent or Baby uni

2 WARNINGS AND SAFETY INFORMATIONBattery requirementsEach parent unit requires two rechargeable Ni-MH batteries, size AA 1.2V 1300mAh.• Do not dispos

3Installation and ChargerFor the Parent Unit1 Remove the battery cover on the back of the Parent Unit by pressing and sliding it down. Insert the rec

44 Press [ ] to turn the Parent Unit on. • Before fi rst use, or if it has been out of use for a long time, the Parent Unit will need to be charged

5GETTING STARTEDWall mounting the Baby UnitUse the following wall mount diagram to locate and install the mounting pins/screws if you prefer to wall m

6 YOUR BABY MONITORBaby unit (Sender)PagePress to page the Parent unit – useful for fi nding when it is misplaced.Power on/offPress to switch on or off

7YOUR BABY MONITORBack of Baby unitUndersidePower socketFor connectionto mains power.Battery lockChild tamper proof lock for the battery compartment.